Analog DevicesADL5513-EVALZアンプIC開発ボードおよびキット

ADL5513-EVALZ is a fully populated, 4-layer, FR4-based evaluation board. For normal operation, it requires a 5 V/50 mA power supply. The power supply should be connected to the test loops labeled VPOS and GND. The RF input signal is applied through the SMA connector labeled RFIN. The output signal is accessable through the SMA connector labeled VOUT. The temperature adjust node is connected through a test loop mounted on the circuit board. Optionally a voltage divider powered by VPOS can be constructed using resistors, R8 and R9. The circuit board can also accommode a 26 pin header through which the power supply, ground, temperature adjust node and output signal pins are accessable. The circuit board ships without this header installed.

• ADL5513 Gerber Files
• ADL5513: 1 MHz to 4 GHz, 80 dB Logarithmic Detector/Controller Data Sheet (Rev 0, 11/2008)