Analog DevicesEVAL-ADM1186-2EBZPower Management Development Boards and Kits

The evaluation allows a user to perform controlled up and down sequences of four supplies. The main evaluation kits allow simulated fault conditions on each on-board supply or on a control signal. All kits provide the ability to single-step and observe the behavior of the state machine during the power-up and power-down sequence.

ADM1186-2 can be used to turn on and off four supplies in sequence under the control of a state machine, and can monitor the supplies to ensure that they are above a user defined undervoltage (UV) threshold. If any supply drops below the UV threshold, a fault occurs and the state machine turns all the supplies off.

• 4 on-board variables supplies with LEDs to show status
• LEDs to show power good, fault, and sequence done (main evaluation kits only)
• Switchable capacitors to set time delays (main evaluation kits only)
• Manual fault push switch
• Single step mode

• EVAL-ADM1186-2EBZ evaluation board, along with some the ADM1186-2 parts.

EVAL-ADM1186: Evaluation Kits for ADM1186 Quad Sequencer and Monitor  (pdf, 573 kB)